Dacor ERV48ER Manual de usuario

Installation InstructionsDowndraft Raised VentModels: ERV36-ER, ERV48-ERPart No. 103106 Rev. FUse these downdraft raised vents only with approved Da

8Cut and remove the foil material inside the knock-out 2. hole. If you fail to remove the foil, the vent will not work.If the unit will vent through t

9Gently slide the vent into the rear of the countertop cut-5. out with the electrical access panel toward the front.Loosely attach the anchoring legs

10Installation InstructionsGroundPowerInputBlowerOutputElectrical access panelERV Electrical Access PanelERV Raised Vent Front ViewTo power wires/con

11Installation InstructionsExample of Installation with Bottom Exhaust(Side View)REMP series remote blowerConnect wires/conduit according to remote bl

12Installation InstructionsVerifying Proper Operation WARNINGRead the raised vent use and care manual complete-•ly before operation.Install all of th

13Wiring DiagramSTUDCHASSISGROUNDGROUNDPOWERINPUTBLOWEROUTPUTGNDL2 N1L1N2 GNDCOMCOMNONOUPPERLIMIT SWITCHLOWERLIMIT SWITCHCOM NCNONCNCREMOTE POTSNORKEL

Dacor ● Phone: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com

Installation Instructions ... 8Installation Preparation ...

1Important Information About Safety InstructionsThe • Important Safety Instructions and warnings in these instructions are not meant to cover all pos

2Important Safety InstructionsDo not install or operate a damaged appliance. If you •receive a damaged appliance, contact your dealer or builder.For

3Product DimensionsProduct Specifications30 ¼"(768 mm)to37 ¼"(946 mm)10"(254 mm)30"(762 mm)18 5/8”(473 mm)5/16” (8 mm)thick stiffe

4Planning the InstallationGeneral System LayoutThe vent system consists of the raised vent itself and a sin-gle Dacor approved remote or in-line blowe

5Installation SpecificationsThe raised vent exhaust may be configured to vent •through the back, the bottom or through one of the sides. The maximum

6Installation SpecificationsWhen connecting the duct work to the back of the unit, •the customer must supply a 3 ¼” X 10” rectangular transition to m

7On side exhaust installations, allow five inches of space •on the side for the ADT2 exhaust transition plus addi-tional space for the duct attached