Dacor ID30 Especificaciones

Installation InstructionsEpicure® 30-Inch DishwasherFor use with models: ED30, ID30Part No. 65538 Rev. F

8Installation InstructionsTo adjust the rear leveling legs, rotate the #2 Phillips drive shafts, located at the toe-kick, to level the dishwasher from

9Cabinet Panel Installation (Model ID30 Only) CAUTIONThe provided mounting screws are designed for panels with a thickness of 5/8” to 3/4”. Smaller pa

10Installation Instructions20"Min.Create loop and fasten to under side of cabinetFloorDISPOSAL INSTALLATION WITHOUT AIR GAP20"Min.Create loo

11Installation InstructionsFinal Electrical Installation WARNINGSTo avoid electrical shock or fire hazard, make sure the power supply at the fuse or j

12You should hear the dishwasher drain and then begin to fill with water. Wait approximately two minutes, then carefully open the door to verify water

Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com

All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications.© 2007 Dacor, all rights reserved.

1Before You Begin ... 1Important Safety Instructions ...

2Important Safety Instructions WARNINGDo not install or operate this dishwasher if it has been damaged, dropped, has damaged electrical conduit or wir

3Product SpecificationsDimensions47" (1194mm)** Allows for drain hose on back of unit19 1/4" (489mm) to20 1/4" (514mm)*36 1/4"(921

4Preparing for InstallationThe floor must be level and all cut-out surfaces at right angles. The dishwasher must be secured to the adjacent cabinets u

5Power Supply WARNINGThe electrical power supply for the dishwasher should be installed only by a licensed electrician.Electrical SpecificationsIt is

6Verify the Package ContentsNOTE: Model ID30 ships without a front panel. It is designed for the installation of an integrated front panel that matche

7Installation Instructions WARNINGDo not connect the electrical, water inlet or drain until instructed to do so in the Verifying Proper Operation sec