Dacor HGER30SLP Guía de instalación descargar pdf (Pagina 15)

Verifying Proper Operation

Before operating the range, read the User Manual completely. It

contains important safety, service, and warranty information.

1. Ensure that all control knobs are off and all burner components are

properly assembled.

2. Open the gas-supply valve.

3. Plug in the range.



When the blinking stops, go to Step 4.

4. Test a burner by push-turning the knob to HIGH (flame icon).

Ignition may take 4 seconds, at which time the sparking stops.

If there is no ignition within 4 seconds, turn off the knob, wait 5

minutes for gas to dissipate, and retest.

5. After ignition, turn the knob to LOW, and observe the flame, which

should be steady and quiet with a sharp,

blue inner cone that varies in length

with burner size. Dacor’s Smart Flame™

feature shortens the flame under the

grate fingers to lengthen grate life. (If the

range is equipped for LP gas, the flame

tips are normally yellow.)

6. Turn the burner OFF, and repeat the test

for the other burners, turning each burner

off when done.

7. Open the oven door. On the control panel, turn on/off the light switch

to verify it works., then turn on/off the convection fan (behind the

convection filter on the back wall). You should hear the fan blades.

8. 

ON indicator should illuminate. Within 1 minute, the bake burner

(bottom of the oven) should ignite and give off heat.

 Turn the oven to BROIL. The bake burner should turn off. The knob

and oven ON indicator should remain illuminated. Within 1 minute,

the IR burner (top of the oven) should ignite and give off heat.

 Turn off the oven.

If the range does not operate properly:

1. Verify that power and gas are supplied to the range.

2. Verify correct installation of electrical connections and gas supply.

3. Repeat the burner/oven tests.

If the range still does not work, contact Dacor Customer Assurance: (833)

353-5483. Have the model and serial numbers available when you call.

(See the inside cover for location.) Do not try to repair the range.

Dacor is

not financially responsible for correcting problems due to faulty

installation.

Moving the Range for Service

1. Close the gas valve, and unplug the range.

2. Pull the range away from the wall.

3. Push the range into position, ensuring the anti-tip foot engages the

bracket (see Final Installation, Pg. 11).

4. Plug in the range, and open the gas valve.

Installation Checklist

WARNING

• To ensure safe and proper installation, the installer should

complete this checklist.

• The owner shall is ultimately responsible for the range’s proper

installation.

F Was the plastic coating peeled off the range?

F Was all packaging removed from the oven chamber?

F Do all leveling legs touch the floor? Is the unit level? (Pg 11)

F 

F Is the gas-inlet pressure within the specified maximums? (Pg. 5)

F Were all joints and outlets checked for gas leaks?

F Is the range connected to the gas supply according to instructions

and applicable codes?

F Is the oven door properly installed? (Pg. 11)

F Are the burner knobs properly installed? (Pg. 11)

F Are the burners and grates properly installed? (Pg. 12)

F Was proper operation verified?

F Was the warranty activated on-line or the warranty card filled out

and mailed?

Installation Instructions

Normal

Flame

1 2 ... 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Dacor HGER30SLP Guía de instalación Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para No Dacor HGER30SLP