
Page 9-28
DACOR RANGE SERVICE MANUAL
Light Fixture Removal
Trace the light fixture wire up into the
space M above the oven chamber. Find the
connector on the wire inside, and disconnect
it.
•
Oven Component Repair (continued)
CAUTION
Use the lens pry stick with caution. Do
not cause uneven stress on the lens.
Do not touch halogen light bulbs with
your hand. Hand oils left on the bulb will
cause early failure.
•
•
M
Gently insert the pointed end of the lens pry
stick (Dacor Part No. 62974), supplied with
the range, under the center edge of the lens.
Hold your hand under the lens for support,
then pull it straight out.
Using a glove, pull the light bulb straight out
of the light socket (do not turn).
Pull the light fixture out of the hole in the side
of the oven, pulling the wire and connector
with it. Use a screwdriver, if necessary, to
move the insulation around behind the hole
to allow the connector to slide out of the wall
into the oven chamber.
Gently push the connector and wire attached
to the replacement light fixture through the
hole and insulation in the wall of the oven.
Use a screwdriver, if necessary, to move the
insulation around behind the hole to allow the
connector to pass through to the outside of
the oven chamber.
Route the light fixture wire into the space
above the oven chamber and reconnect it.
Using a glove, insert the bulb into the
replacement light fixture socket. If replacing
the bulb, use only Dacor light bulb Part No.
100429. Using a screwdriver, pry the locking
tabs opposite socket of the old light fixture
out. Prying the tabs out will allow the fixture
to be removed from the oven wall.
Reinstall the lens cover by aligning the cover
over the opening and gently pressing it into
its original position. Be sure that the side of
the lens cover with the cutout lines up with
the light socket.
•
•
•
•
•
•
•
Comentarios a estos manuales