Dacor CM24P-1 Guía para resolver problemas descargar pdf (Pagina 18)

Dishwasher Factory Test Mode

24” Models: ID24, ED24SCH, ED24SCP, ED24SBK, ED24SBR, PD24 (all

colors), MDV24S & MDH24S

30” Models

: ID30, ED30SCH, ED30SCP, ED30SBK & ED30SBR

Factory Test Mode:

The Factory Test Mode, or FTM, is run on each unit during final QC to ensure

that all of the components are operating normally. The FTM runs the unit

through an abbreviated wash cycle and checks various sensors for response and

is a valuable diagnostic tool. By knowing the timing of the FTM (shown below), a

technician can check for operation of the component in question at the expected

time.

MAKE SURE THAT THE UNIT IS SAFE TO OPERATE, AND ALL PLUMBING

CONNECTIONS ARE MADE PRIOR TO RUNNING THE FACTORY TEST MODE.

To Enter the FTM:

1. Press the SECURE key for three (3) seconds. Then press the SECURE key

again for three (3) seconds to exit the secure mode.

2. Press DELAY and SANI RINSE keys simultaneously to start the factory test

mode.

3. Close the dishwasher door. Be sure to close the detergent dispenser prior to

initiating the FTM to check for proper operation.

4. All LED’s on the dishwasher will turn ON for about 15 seconds then turn off.

5. The factory test will begin. Use the timing chart below for expected operation

timing of the component in question.

If during the FTM one of the electric components fails to operate at the

scheduled time, it is likely that either the component has failed, the wiring has

failed or the Power Board has partially failed. Start by checking the component in

question and working back to the Power Board. Use extreme caution when

working with live components.

After test has been completed, press CANCEL key once to exit from the factory

test mode. To exit the factory test mode at anytime, press the CANCEL key once.

If the FTM has completed without error, a solid green light at the bottom of the

door (ED model only) and three beeps will signal that all the major components

are operating correctly.

Below is a timing schedule for the factory test:

Component Duration Comments

Drain Pump 30 sec Control Board Version Displayed

Inlet Valve 60 sec Power Board software1 version displayed

Pause 20 sec Power Board software2 version displayed

Circ Pump & Heater 300 sec

Dispenser 5 sec

Drain Pump 30 sec

Dacor Tec-Line: 800-353-2267

PG: 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Comentarios a estos manuales

Sin comentarios

Dacor CM24P-1 Guía para resolver problemas Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Dacor CM24P-1