Dacor CM24P-1 Guía para resolver problemas descargar pdf (Pagina 30)

Diagnostic Test Mode

There are several test modes available through the diagnostic system. Use of these test modes can

greatly decrease the time needed for troubleshooting. It is to the service technician’s advantage to

be able to perform many tests in a very short period of time.

Pre-Diagnostics Checks

• Confirm the refrigerator and freezer temperatures before beginning other checks.

• See if the compressor, evaporator, and condenser fans are running.

• Check the position of the air door.

Diagnostics Mode:

The Diagnostics Mode is used to:

• Check the refrigerator & freezer thermistors.

• Operate the evaporator fan motor at 3000 rpm.

• Operate the condenser fan motor and compressor.

• Check the defrost bimetal and heater.

To enter the diagnostics mode:

To enter the Diagnostics Mode, the control must be turned on, and be in a normal cooling mode.

Both the Power On/Off and the Water Filter Reset keys must be functional. The refrigerator display shows

the step number. The results of the checks are displayed on the water filter status indicator. After 20

minutes, the control will default from the Diagnostics Mode to a normal cooling mode.

• Press and hold the Water Filter Reset keypad, and then immediately press and hold the Power keypad.

Continue to press both keypads for 3 seconds, or until you hear a beep.

To advance the Diagnostics Sequence:

• To advance to the next step in the sequence, press and hold the Water Filter Reset key for 2 seconds or

until you hear a beep. The Diagnostics Chart on the next page shows the step number and the component

being tested in each step.

SERVICE TIP: If the control does not respond, it may be necessary to remove power from the entire

appliance for a few seconds. Reapply power and perform the service diagnostics routine again to verify that

the control is working properly.

Dacor 36”, 42” and 48” Built-in Refrigerator Diagnostics (Second Generation):

Models: EF36LNBSS / EF36RNBSS / IF36LNBOL / IF36RNBOL / EF42NBSS / EF42DBSS / IF42NBOL /

IF42DBOL / EF48NBSS / EF48DBSS / IF48NBOL / IF48DBOL

Dacor Technical Assistance: 800-353-2267

PG: 30

1 2 ... 25 26 27 28 29 30 31 32 33

Sin comentarios

Dacor CM24P-1 Guía para resolver problemas Pagina 30